Setting The Independent Key Transition Rate - Sony XVS-G1 User Manual

Setting the independent key transition
type (menu)
This section describes the M/E-1 key 1 menu as an
example.
1
Open the Home > M/E-1 > Key1 > Transition >
Transition Type menu (11101.51).
2
Select a transition type in the [Transition Type] group.
Mix: Mix
Wipe: Wipe
DME Wipe: DME wipe
Cut: Cut
When an operation mode that supports configuration
of transitions where keys are inserted/removed
independently is set, select a transition type for key
insertion in the [ON Transition Type] group and a
transition type for key removal in the [OFF Transition
Type] group.
3
Set the transition type.
Make the required settings for the selected transition
type.
When a mix, wipe, or DME wipe is selected
Set the transition rate.
For details about the transition rate, see "Setting the
Independent Key Transition Rate" (page 68).
When a wipe is selected
Set the wipe pattern.
For details, see "Setting an Independent Key
Transition Wipe" (page 108).
When a DME wipe is selected
Set the DME wipe pattern.
For details, see "Setting an Independent Key
Transition DME Wipe" (page 120).
Setting the Independent Key
Transition Rate
You can set the time taken from the beginning of an
independent key transition to its completion.
The independent key transition rate is configured using the
menu.
Note
When an operation mode that supports configuration of
transitions where keys are inserted/removed independently
is set, the transition rate for inserting and removing keys
can be set separately.
For details about independent key transition operation
mode, see "Setting the Independent Key Transition Mode"
(page 311).
This section describes the M/E-1 key 1 menu as an
example.
1
Open the Home > M/E-1 > Key1 > Transition >
Transition Type menu (11101.51).
2
Select a transition type in the [Transition Type] group.
When an operation mode that supports configuration
of transitions where keys are inserted/removed
independently is set, select a transition type for key
insertion in the [ON Transition Type] group and a
transition type for key removal in the [OFF Transition
Type] group.
3
Set the transition rate using the following parameter.
No. Parameter
1 Transition Rate
Note
When a cut is selected as the transition type, it is not
possible to set the transition rate.
To set the transition rate in list view
You can set the transition rate in transition rate list view on
each switcher bank.
1
Open the Home > Utility > Transition Rate menu
(18201.21).
The transition rate for common transitions and
independent key transitions is displayed for each
switcher bank.
2
Select the target switcher bank to set.
3
Press the [Edit] button.
The transition rate setup window appears.
4
Press a [Key1] to [Key8] button and enter a transition
rate in the numeric keypad window.
When an operation mode that supports configuration
of transitions where keys are inserted/removed
independently is set, select a transition type for key
insertion using a [Key1] to [Key8] button in [Key On]
and a transition type for key removal using a [Key1] to
[Key8] button in [Key Off].
5
Press [OK].
68
Adjustment
Transition rate