Executing A Pattern Limit - Sony XVS-G1 User Manual

1
Move the fader lever to the position corresponding to
the desired pattern size.
2
Press the [LIMIT SET] button.
This sets the current fader lever position as the pattern
limit.
Setting a pattern limit (menu)
This section describes the M/E-1 menu as an example.
1
Open the pattern limit setting menu.
When the transition type is a wipe, open the Home >
M/E-1 > Bus/Transition > Wipe > Pattern Mix/Edge/
Direction menu (11109.33).
When the transition type is a DME wipe, open the
Home > M/E-1 > Bus/Transition > DME Wipe >
Edge/Direction menu (11109.44).
2
Set the [Pattern Limit] button to the on state and set the
following parameter.
No. Parameter
1 Pattern Limit

Executing a Pattern Limit

1
Press the [PTN LIMIT] button in the transition control
block, turning it on.
The [PTN LIMIT] button is lit amber.
2
Execute a transition.
The transition progresses as far as the set pattern limit.
3
Execute the transition once again.
The state existing before executing the transition is
restored.
Releasing a pattern limit
When the state existing before executing the transition is
restored by performing step 3, press the [PTN LIMIT]
button to release a pattern limit, turning the [PTN LIMIT]
button off.
To release a pattern limit in pattern limit state, execute a
transition using the following procedure.
You can set the operation mode for executing a transition
when releasing a pattern limit to manual or auto.
Adjustment
Pattern limit range (0.00% to
100.00%)
For details about setting the operation mode, see "Setting
the Operation Mode When the Pattern Limit is Released"
(page 314).
1
Press the [PTN LIMIT] button in the transition control
block.
The [PTN LIMIT] button is lit green.
2
Execute a transition.
If the operation mode when a pattern limit is
released is set to auto
Press the [PTN LIMIT] button to execute the
remainder of the transition automatically with the
preset transition rate. When the transition is
completed, the pattern limit is released and the [PTN
LIMIT] button turns off.
If the operation mode when a pattern limit is
released is set to manual
Execute the remainder of the transition using one of
the following methods. When the transition is
completed, the [PTN LIMIT] button turns off.
• Press the [CUT] button.
The image switches instantaneously and the pattern
limit is released.
• Press the [AUTO TRANS] button.
The remainder of the transition is executed with the
preset transition rate and the pattern limit is released
when execution is completed.
• Operate the fader lever.
If the fader lever is moved in the execution direction
of the transition, the remainder of the transition is
executed and the pattern limit is released when
execution is completed.
If the fader lever is moved in the opposite direction,
the transition is executed such that the state before
executing the transition is restored, and the pattern
limit is released when execution is completed.
To set the transition rate when the pattern limit is
released
This section describes the M/E-1 menu as an example.
1
Open the pattern limit setting menu.
When the transition type is a wipe, open the Home >
M/E-1 > Bus/Transition > Wipe > Pattern Mix/Edge/
Direction menu (11109.33).
When the transition type is a DME wipe, open the
Home > M/E-1 > Bus/Transition > DME Wipe >
Edge/Direction menu (11109.44).
2
Set the transition rate in the [Pattern Limit Release]
group.
Auto Trans Rate: Follow the current transition rate.
64