Aux Bus Color Corrector - Sony XVS-G1 User Manual

Executing an AUX mix (cross-point control
block)
This section describes an AUX mix using the AUX1 bus
and AUX2 bus as an example.
This switches from the image currently output on the
AUX1 bus to a new image using an AUX mix.
Notes
• The button used to execute an AUX mix must be
assigned to the function button section of the cross-point
control block beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).
• The AUX mix transition rate is configured using the
menu.
For details about settings, see "Executing an AUX mix
(menu)" (page 185).
1
Press the [AUX MIX] button, turning it on.
Use the [AUX MIX] button for the cross-point button
row assigned with the AUX1 bus.
2
Select an image for after the transition in the cross-
point button row assigned with the AUX1 bus.
The image during the transition is output on the AUX1
bus.
The selected image is output on the AUX2 bus.
Note
When the output signal conversion format is 2160P
2SI 3G, the image during the transition is also output
on the even-numbered AUX bus.
Executing an AUX mix (menu)
This section describes an AUX mix using the AUX1 bus
and AUX2 bus as an example.
This switches from the image currently output on the
AUX1 bus to a new image using an AUX mix.
1
Open the Home > Other Effects > Aux Bus > Aux Xpt
menu (18102.11).
2
Select the AUX1 bus.
3
Press the [Edit] button.
The AUX1 bus signal selection window appears.
4
In [Aux Mix], set the [On] radio button to the on state.
To disable an AUX mix, set the [Off] radio button to
the on state.
To set the transition rate
Press the button on the right of the [On] radio button
and enter a transition rate in the numeric keypad
window.
To switch the video signal and key signal
To select a video signal, set the [Video] radio button
for [Select Source Type] to the on state.
To select a key signal, set the [Key] radio button for
[Select Source Type] to the on state.
5
Execute an AUX mix using the cross-point selection
buttons.
Select a tab to change the button to display.
Set the cross-point selection button assigned with the
image for after the transition to the on state to execute
the AUX mix.
The image during the transition is output on the AUX1
bus. The selected image is output on the AUX2 bus.
Note
When the output signal conversion format is 2160P
2SI 3G, the image during the transition is also output
on the even-numbered AUX bus.

AUX Bus Color Corrector

You can set the following color corrector functions for
AUX bus outputs.
• Video process
• Primary color correction
• RGB clip
To use a color corrector, an AUX bus must be assigned to
an output that can be configured with a color corrector/
HDR converter.
For details about outputs that can be configured with a
color corrector/HDR converter, see "Selecting Outputs
Configurable with a Color Corrector/HDR Converter"
(page 296).
Notes
• When AUX mix is enabled, the color corrector is set for
odd-numbered AUX buses.
• When the system signal format is 1080P or 1080i, a color
corrector cannot be used.
Setting a color corrector
1
Open the Home > Other Effects > Aux Bus > Aux Bus
CCR menu (18102.21).
The color corrector settings information is displayed
for each AUX bus.
185