Multi Program 2 Mode Restrictions - Sony XVS-G1 User Manual

1
Open the Home > M/E-1 > Common > Key Priority/
Key Assign menu (11110.11).
The key assignment status of the program 1 output to
program 4 output are shown at the bottom.
2
Select the target program output (PGM1 to PGM4) to
set.
3
Press the [Edit] button.
The [Enable Key] window appears.
4
Place a check mark in the keys to enable.
Notes
• SL keys 5 to 8 are enabled/disabled as a group.
• SL keys are disabled for PGM2 to PGM4.
5
Press [OK].
Settings and functions added in multi
program 2 mode
• Sub switcher bank menus (M/E-1 Sub to M/E-5 Sub,
P/P Sub) are added.
• The sub switcher banks (M/E-1 Sub to M/E-5 Sub, P/P
Sub) are added to the menu as setup targets.
• Sub switcher bank regions (M/E-1 Sub to M/E-5 Sub,
P/P Sub) are added.
• Main and sub switcher banks and keys are shown on the
transition control block display.
Switcher banks: MAIN (dedicated main), SUB
(dedicated sub), MAIN&SUB (shared main and sub)
Keys: M (key assigned to main), S (key assigned to sub)
• When extended re-entry is enabled for switcher banks,
re-entry signals within the main switcher bank, within
the sub switcher bank, and between main and sub
switcher banks can be selected.
For details about extended re-entry, see "Setting
Extended Re-Entry" (page 308).
• "Sub" and "Main&Sub" settings are added to macro
event parameters and macro attachment list buttons.
For details about macro events, see "Macro Events"
(page 377).
For details about macro attachment lists, see "Macro
Attachment Lists" (page 384).
• Sub switcher bank preview is added to the utility
commands.
For details about utility commands, see "List of Utility
Commands" (page 178).
Image creation operation
This section describes the operation of a switcher bank
shared between main and sub as an example.
To switch between main and sub, press the [MAIN] button
or [SUB] button in the cross-point control block.
Note
The [MAIN] button and [SUB] button must be assigned to
the function button section of the cross-point control block
beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).
1
Press the [MAIN] button, turning it on.
If the [SUB] button is lit, press the [SUB] button,
turning it off.
2
Create the main side image.
3
Press the [MAIN] button, turning it off.
4
Press the [SUB] button, turning it on.
5
Create the sub side image.
6
Press the [MAIN] button, turning it on.
Both the [MAIN] button and [SUB] button should be
turned on.
Note
When both the [MAIN] button and [SUB] button are
selected, the control panel shows the status of the main
side.
7
Execute a transition.
Both main side and sub side images are switched.

Multi Program 2 Mode Restrictions

In multi program 2 mode, settings and functions have the
following restrictions.
• A key wipe has the following restrictions.
- Only standard wipe patterns can be used
- Pattern mix cannot be used
- Split, pairing, modulation, spring, and spiral cannot be
used
- Edge fill color matte is flat color only
- Four types of multi replication are available for
selection
• The key priority cannot be changed, depending on the
transition.
• Transition preview cannot be used.
• DMEs can be used in up to two locations simultaneously
on main and sub.
- When using a DME wipe only
1-channel mode DME wipe: Can be used separately on
main and sub.
183