Executing An Independent Key Transition - Sony XVS-G1 User Manual

Executing an Independent Key
Transition
The independent key transition is configured using the
transition control block or the menu.
Note
In an independent key transition, the pattern limit function
is not available.

Executing an independent key transition

(transition control block)
Independent key transition execution section
Note
The buttons used for an independent key transition must be
assigned to the independent key transition execution
section of the transition control block beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).
To insert/remove a key instantaneously
Press a [KEY1 ON] to [KEY8 ON] button.
To insert/remove a key with the preset transition
type and transition rate
Press a [KEY1 TRANS] to [KEY8 TRANS] button.
During the transition execution, the button is lit amber and
goes off when the transition is completed.
Notes
• You can change this so that during the execution of the
transition, the button is lit green and when the transition
is completed it is lit red if on-air or lit amber if not on-air.
For details about settings, see "Setting the independent
key transition, auto transition execution button display"
(page 324).
• When a cut is selected as the transition type, the key is
inserted/removed instantaneously.
Executing an independent key transition
(menu)
This section describes the M/E-1 key 1 menu as an
example.
1
Open the Home > M/E-1 > Key1 > Key Snapshot
menu (11101.71).
2
Execute a transition.
To insert/remove a key instantaneously
Press the [KEY ON] button.
To insert/remove a key with the preset transition
type and transition rate
Press the [KEY TRANS] button.
Note
When a cut is selected as the transition type, the key is
inserted/removed instantaneously.
69