Setting The Signal Format; Setting The Signal Format And Frequency; Setting The Reference Signal; Setting The Image Switch Timing - Sony XVS-G1 User Manual

Setting the Signal Format

Setting the Signal Format and
Frequency
You can select the system signal format and the field
frequency/frame frequency.
The combinations of signal format and frequency that can
be set are as follows.
Signal format
4K 2160P 2SI
HD 1080P
1080i
Note
To use 4K formats, the XZS-G1500 4K Upgrade License
(option) is required.
1
Open the Home > Setup > System > Format/Config >
Format menu (19101.22).
2
In the [Signal Format] group, select a signal format.
3
In the [Frequency] group, select a frequency.
4
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
5
Check the message, then press [OK].
The switcher system reboots.

Setting the Reference Signal

You can set the input/output reference signal to HD tri-
level sync or black burst.
Setting the reference signal lock mode
1
Open the Home > Setup > System > Format/Config >
Format menu (19101.22).
2
In the [Ref Lock Mode] group, select a lock mode.
External: External lock mode
Sync to input reference signal.
Setting the input reference signal
Cannot be set when the reference signal is in internal lock
mode.
1
Frequency
2
59.94
50
59.94
50
59.94
50
Setting the output reference signal
1
2

Setting the Image Switch Timing

1
2

Setting the Reference Phase

1
2
287
Internal: Internal lock mode
Use switcher internal signal as the reference
signal.
Note
Open the Home > Setup > System > Format/Config >
Format menu (19101.22).
In the [Ref Input Format] group, select a reference
signal.
Tri Sync: HD tri-level sync
BB: Black burst or sync
Open the Home > Setup > System > Format/Config >
Format menu (19101.22).
In the [Ref Output Format] group, select a reference
signal.
Tri Sync: HD tri-level sync
BB: Black burst or sync
Open the Home > Setup > System > Format/Config >
Format menu (19101.22).
In the [Switch Timing] group, select the switch timing.
Any: Not specified
Field1: Field 1
Field2: Field 2
Open the Home > Setup > System > Format/Config >
Format menu (19101.22).
Press the [System Phase] button and enter a reference
phase (microseconds) in the numeric keypad window.