Setting The Operation Mode Of The Cross-Point Control Block Button Rows - Sony XVS-9000 User Manual

2
In the <Macro Execution Mode> group, select the
macro execution mode.
Normal: Normal execution
Step: Step execution
3
In the <Attachment Setting Mode> group, select the
button operations when a macro attachment is set.
With Btn Function: Simultaneously execute button
function.
W/o Btn Function: Do not execute button function.
4
In the <Macro 2nd Recall Mode> group, select the
action to occur during macro execution or when a
macro is paused if the same macro is executed again.
Continue: If the macro is executed by operation of a
button with a macro attachment, execution of a
paused macro is resumed, and execution of an
executing macro continues as-is. If the macro is
executed by any method other than a macro
attachment, execution starts from the first event.
Cancel: A paused macro or a macro during execution
is terminated.
5
In the <Macro Recall Override> group, select the
action to occur during macro execution or when a
macro is paused if another macro is recalled.
Disable: Ignore the other macro recall.
Enable: Execute the other macro.
6
In the <Macro Attach Enable Setting Mode> group,
select the enable/disable setting mode for macro
attachments.
Manual: Enable/disable using the [MACRO
ATTACH ENABLE] button on the cross-point
pad of the cross-point control block or the button
assigned with the "Macro Attachment Enbl"
utility command.
Enable: Always enable macro attachments.
Disable: Always disable macro attachments.
To set a cross-point button with a macro
attachment lit continuously
Press [Attchd Btn Indication], turning it on.
When macro attachments for the cross-point control block
are enabled, cross-point buttons with a macro attachment
are always lit green.
Setting the Operation Mode of the
Cross-Point Control Block Button
Rows
1
In the Engineering Setup >Panel >Operation menu
(7326), press [Xpt Module Operation].
The Xpt Module Operation menu (7326.12) appears.
2
In the <Bank Select> group, select the target bank to
set.
3
In the <Row Mode> group, select one of the following.
Key Bus: Use the 1st row and 2nd row as cross-point
button rows for the bus/function selected by a
delegation button on the cross-point pad (key bus
mode).
Use the 3rd row as a cross-point button row for
background A bus, and the 4th row for background
B bus.
Free Assign: Use the 1st row to 4th row as cross-point
button rows for the bus/function selected by a
delegation button on the cross-point pad (free
assign mode).
Key Deleg/AUX: Use the 1st row as a delegation
button row, and the 2nd row as a cross-point
button row for the bus/function selected by a 1st
row button (key/AUX bus delegation mode).
Use the 3rd row as a cross-point button row for
background A bus, and the 4th row for background
B bus.
Assigning a bus/function to a 1st row
delegation button
You can set delegation buttons in key/AUX bus delegation
mode.
1
In the Engineering Setup >Panel >Operation >Xpt
Module Operation menu (7326.12), press [Key Deleg/
AUX Assign].
The Key Deleg/AUX Assign menu (7326.13) appears.
The left side of the status area shows the 1st row button
numbers and the assigned buses/function names, and
the right side shows a list of assignable buses/function
names.
2
In the <Bank Select> group, select the target bank to
set.
3
Select the target button number to set.
4
Select a bus/function to assign.
5
Press [Set].
424