Setting External Devices; Setting The P-Bus Control Mode; Setting The Aux Bus Override Mode; Setting Channel Selection Buttons - Sony XVS-G1 User Manual

Setting External Devices

Setting the P-Bus Control Mode

You can set the mode for controlling P-Bus compatible
devices.
For details, see "P-Bus control modes" (page 173).
1
Open the Home > Setup > Panel > External Device >
GPI/P-Bus menu (19104.41).
2
In the [P-Bus Control] group, select a P-Bus control
mode.
Trigger: P-Bus trigger
Timeline: P-Bus timeline

Setting the AUX Bus Override Mode

You can set the operation mode when "Aux1 to 48 Bus
Override" is selected if the trigger type is set to "Rising
Edge" or "Falling Edge" for a GPI input.
1
Open the Home > Setup > Panel > External Device >
GPI/P-Bus menu (19104.41).
2
In the [Aux Bus Override Mode] group, select an AUX
bus override mode.
Momentary: On an input pulse rising (falling) edge,
the input of the selected AUX bus is used, and on
a falling (rising) edge it returns to the original
cross-point.
Latch: On an input pulse rising (falling) edge, the
input of the selected AUX bus is used, and it does
not return to the original cross-point even on a
falling (rising) edge.

Setting Channel Selection Buttons

You can assign a serial port or a network port to a channel
selection button in the device control block.
This allows you to operate a device connected to the port
using the specified channel selection button.
1
Open the Home > Setup > Panel > External Device >
Device Channel Assign menu (19104.42).
2
Select the target port to set.
Note
A port configured with a P-Bus compatible device
cannot be assigned to a channel selection button.
3
Press the [Device Channel] button and select a channel
(Device Ch1 to Device Ch12) from the pull-down list.
Configuring file list sharing
You can configure sharing of the same file list, for
example, when the same device is connected to multiple
ports.
Note
File list sharing is enabled only for ports to which a disk
recorder (video disk communications protocol or Odetics
protocol) has been assigned.
1
Open the Home > Setup > Panel > External Device >
Device Channel Assign menu (19104.42).
2
Select the target port to set.
3
Press the [Same File List Channel] button and select a
channel (Device Ch1 to Device Ch12) for sharing a
file list from the pull-down list.
322