Icp-X1224/X1216/X1124/X1116 Control Panel - Sony XVS-G1 User Manual

Can also be used as a tally input/output port.
o Network expansion 4 connector
p Network expansion 3 connector
q Network expansion 2 connector
r Network expansion 1 connector
PCIe slot. Supports third-party network expansion cards.
Used as interface expansion 1 to 4 LAN connectors.
For details, see "Setting the Network Interface"
(page 357).

ICP-X1224/X1216/X1124/X1116 Control Panel

Rear view
The following illustration shows the ICP-X1224.
a DC IN A and B connectors
Connect to the supplied AC adaptor.
b U (signal ground) terminal
Connect to a ground wire.
c LAN A1 connector (RJ-45, 1000BASE-T
compliant)
Connect to the switcher system network via an Ethernet
switch.
Connect to the switcher in system configurations that do
not use an Ethernet switch.
d LAN A2 connector (RJ-45, 1000BASE-T
compliant)
Connect to a computer for menu operations in system
configurations that do not use an Ethernet switch.
e LAN B connector (RJ-45, 1000BASE-T compliant)
Used for LAN A1 connector redundancy.
s REMOTE 1/2, 3/4, 5/6, 7/8 connectors (RJ-45, RS-
422 compliant)
Can be used when an XKS-G1700 Legacy Interface Board
(option) is installed.
Connect to a device that supports VTR (Sony 9-pin VTR
protocol), disk recorder (Video Disk Communications
Protocol, Odetics protocol), or P-Bus (Peripheral Bus II
protocol) protocols.
Can also be used as a tally output port.
a b c d
29
e