Setting A Border - Sony XVS-G1 User Manual

2
Set the [Resizer] button to the on state.
3
Set the [Wrap Around] button to the on state.
The virtual image portions are removed.

Setting a Border

Setting a border (menu)
1
Open the Home > M/E-1 > Key1 > Resizer/Proc Key
> Resizer Adjust/DME Select menu (11101.41).
2
Set the [Resizer] button to the on state.
3
Set the [Border] button to the on state and set the
following parameters.
No. Parameter
1 H
2 V
3 All
4 Density
4
In the [Border Mode] group, select a type of border.
Flat Color: Single color border
Beveled Light Edge: Beveled light edge (border like
an illuminated picture frame)
Beveled Color Edge: Beveled color edge (border like
a colored picture frame)
When the [Flat Color] button is selected, set the
following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
When the [Beveled Light Edge] button is selected, set
the following parameters.
No. Parameter
1 Top
2 Left
3 Right
4 Bottom
Adjustment
Simultaneous adjustment of
border width of left and right
edges
Simultaneous adjustment of
border width of top and bottom
edges
Simultaneous adjustment of
border width of top, bottom,
left, and right edges
Density of border
Adjustment
Luminance
Saturation
Hue
Adjustment
Position of top edge
Position of left edge
Position of right edge
Position of bottom edge
No. Parameter
5 All
When the [Beveled Color Edge] button is selected,
select the target edge (Top, Left, Right, Bottom, All)
to adjust in the [Color Adjust] group and set the
following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
To soften the border
Set the [Border Soft] button to the on state.
When the [Flat Color] button is selected, set the following
parameters.
No. Parameter
1 Inner Soft
When the [Beveled Light Edge] button or [Beveled Color
Edge] button is selected, set the following parameters.
No. Parameter
1 Inner Soft
2 Bound Soft
Setting a border (device control block)
When the border setting is enabled in the menu, you can
adjust the border width of the top, bottom, left, and right
edges using the device control block.
Note
The buttons used for configuring a border must be
assigned to the operation buttons of the device control
block beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).
1
Press the [M/E 1] button.
2
Press the [K1RSZ] button.
3
Press the [RSZR ON] button, turning it on.
4
Press the [BDR/CROP] button, turning it on amber.
5
Adjust the border width using the trackball or Z-ring.
Trackball (horizontal rotation): Adjusts the border
width in the X-axis direction (left/right edges)
91
Adjustment
Simultaneous adjustment of
position of top, bottom, left,
and right edges
Adjustment
Luminance
Saturation
Hue
Adjustment
Softness of inner edge of border
Adjustment
Softness of inner edge of border
Softness of border boundary