Setting Dual M/E; Setting Regions Selected Simultaneously - Sony XVS-G1 User Manual

• Flexi Pad control block
1
Open the Home > Setup > Panel > Config > M/E
Assign menu (19104.11).
The status of the key inhibit settings are displayed in
[Key Inhibit].
Keys with an inhibit setting are displayed in white
characters.
In multi program 2 mode, the status of main and sub
keys is displayed.
2
Select the target switcher bank to set.
3
Press the [Edit] button for [Key Inhibit].
The [Key Inhibit] window appears.
4
Place a check mark in the keys to inhibit operation.
5
Press [OK].

Setting Dual M/E

You can assign the cross-points for the shifted state and
unshifted state of a single switcher bank to two
consecutive M/E banks.
If there are two M/E banks, dual M/E is configured for the
switcher bank on M/E bank 1.
Notes
• Cannot be set if there is only one M/E bank.
• Cannot be set if a switcher bank has not been assigned to
the M/E bank.
1
Open the Home > Setup > Panel > Config > M/E
Assign menu (19104.11).
2
Select the target switcher bank to set.
3
Press the [Assign] button for [Dual M/E].
The switcher bank for M/E bank 1 is set to the shifted
state, and the switcher bank for M/E bank 2 is set to the
unshifted state.
To release the dual M/E setting
Assign a switcher bank to an M/E bank.
For details, see "Assigning a Switcher Bank" (page 315).
Swapping shifted and unshifted
assignments
1
Open the Home > Setup > Panel > Config > M/E
Assign menu (19104.11).
2
Press the [Dual M/E Xpt Swap] button.
On: Set the M/E bank with the higher number to the
unshifted state, and the M/E bank with the lower
number to the shifted state.
Off: Set the M/E bank with the higher number to the
shifted state, and the M/E bank with the lower
number to the unshifted state.
Setting Regions Selected
Simultaneously
You can set the regions that are selected simultaneously
when using the [All Regions] button in the effect timeline
and snapshot menus.
1
Open the Home > Setup > Panel > Config > All
Regions Assign menu (19104.12).
2
Select the target region to set.
To select and set multiple regions, place a check mark
beside the target regions to set.
To select and set all regions, place a check mark in the
Select All checkbox.
3
Set the [Assign] switch to the on state.
316