Setting the Output Signal
This section describes how to set the switcher output
signal.
The number of outputs will vary depending on the system
signal format.
2160P format:
Outputs: Max. 12
Outputs configurable with color corrector/HDR
converter: Max. 3
Outputs configurable with format converter: 6 (odd-
numbered outputs only)
1080P, 1080i formats:
Outputs: Max. 24
Outputs configurable with format converter: 12
(outputs 1 to 12 only)
Notes
• Outputs 13 to 18 can be used when an XKS-G1110
Additional I/O Board (option) is installed.
Outputs 19 to 24 can be used when two XKS-G1110
Additional I/O Boards (option) are installed.
• When the system signal format is 1080P or 1080i, a color
corrector/HDR converter cannot be used.
Assigning an Output Signal
You can assign an output signal.
1
Open the Home > Setup > System > Output > Output
Assign menu (19101.41).
2
Select the target output to set.
To select and set multiple outputs, place a check mark
beside the target outputs to set.
To select and set all outputs, place a check mark in the
Select All checkbox.
3
Press the [Edit] button.
The [Output Assign] window appears.
4
Set the button for the signal to assign to the on state.
Select a tab to change the type of signal to display.
[PP/ME Out] tab: Switcher bank outputs
[CB/DME/FM/Clip/MV] tab: Color background/
DME/frame memory/clip player/multi viewer
outputs
[Aux] tab: AUX outputs
[Aux Mix] tab: AUX mix outputs
Note
An AUX output signal cannot be assigned to more
than one output. When multiple outputs are selected,
the [Aux] and [Aux Mix] tab are not displayed.
5
Press [OK].
Assignable signals
[PP/ME Out] tab:
P/P Out1 to P/P Out8
M/E-x Out1 to M/E-x Out8 ("x" is 1 to 5)
[CB/DME/FM/Clip/MV] tab:
Undefined (when signal is not assigned)
Color Bkgd2
DME Monitor Video
DME Monitor Key
Frame Memory1 to Frame Memory16
Clip Player1 to Clip Player4
Multi Viewer1 to Multi Viewer2
[Aux] tab:
Aux1 to Aux48
Edit Preview
Preset
[Aux Mix] tab:
Aux1/2 to Aux47/48
1) The assigned signal name is displayed in the Home > Setup > Switcher >
Config > M/E Config menu (19103.12).
Selecting Outputs Configurable with
a Color Corrector/HDR Converter
You can set outputs that can be configured with a color
corrector/HDR converter.
Notes
• Configurable only when the system signal format is
2160P.
• Up to three outputs can be configured with a color
corrector/HDR converter.
1
Open the Home > Setup > System > Output > Output
Assign menu (19101.41).
2
Select the target output to set.
To select and set multiple outputs, place a check mark
beside the target outputs to set.
3
Set the [CCR/HDR] switch to the on state.
Note
If the maximum number of outputs that can be
configured has been reached, set the [CCR/HDR]
296
1)
1)