Transition Rate; Transition Rate Input/Display Mode; Setting The Transition Rate - Sony XVS-G1 User Manual

Transition Rate

You can set the time taken from the beginning of a
transition to its completion.
The transition rate is configured using the Flexi Pad
control block or the menu.
Note
When a clip transition is selected as the transition type, it
is not possible to set the transition rate.

Transition Rate Input/Display Mode

Transition rate input mode
When entering the transition rate, you can select either
frame number input or timecode input.
For details, see "Timecode input and frame number input"
(page 43).
Frame number input:
Enter a number in the range 0 to 999 frames.
Timecode input:
Enter a value converted to frames of up to 999 frames.
Transition rate display mode
You can set the transition rate display mode to frame
number display or timecode display.
The display mode settings are common to all switcher
banks.
For details, see "Setting the transition rate display"
(page 324).
Frame number display:
Displays the number of frames (0 to 999). Values
entered in timecode input mode are converted to the
number of frames for display.
Timecode display:
Displays a "ss:ff" timecode value (second:frame).
Values entered in frame input mode are converted to a
timecode for display.

Setting the Transition Rate

You can set the speed at which a transition switches from
the current image to a new image (time taken from the
beginning of a transition to its completion).
In an auto transition, the transition is executed
automatically with the preset transition rate.
Setting the transition rate (Flexi Pad
control block)
You can set the transition rate using the Flexi Pad control
block of the target switcher bank.
1
Press the [TRANS RATE] button.
The memory recall section switches to transition rate
operation mode.
2
Enter a transition rate using the number input buttons.
You can switch the input mode using the [TC] button.
In frame number input mode, enter three digits. In
timecode input mode, enter four digits.
The entered value appears in the top right button of the
memory recall section.
To delete the entered value
Press the [CLEAR] button.
3
Press the [ENTER] button.
Setting the transition rate (menu)
This section describes the M/E-1 menu as an example.
1
Open the Home > M/E-1 > Bus/Transition >
Transition > Transition Type menu (11109.21).
2
Select a transition type in the [Transition Type] group.
3
Set the transition rate using the following parameter.
No. Parameter
1 Transition Rate
To set the transition rate in list view
You can set the transition rate in transition rate list view on
each switcher bank.
1
Open the Home > Utility > Transition Rate menu
(18201.21).
The transition rate for common transitions and
independent key transitions is displayed for each
switcher bank.
2
Select the target switcher bank to set.
3
Press the [Common] button and enter a transition rate
in the numeric keypad window.
In multi program 2 mode, enter a transition rate for
main using the [Common] button, and a transition rate
for sub using the [Sub Common] button.
60
Adjustment
Transition rate