Setting Interpolation Processing - Sony XVS-G1 User Manual

No. Parameter
2 Gain
Note
If a DME channel is assigned as the 1st channel or is
not assigned at all, only the [Ext Key] button can be
selected.
3
In the [Back Key] group, select a key source signal for
the image on the back side.
Ext Key: Key signal sent from the switcher
Int Key: DME internal key signal
Linear Key: Luminance signal of the input video
signal
When the [Linear Key] button is selected, set the
following parameters.
No. Parameter
1 Clip
2 Gain
Note
If a DME channel is assigned as the 1st channel or is
not assigned at all, only the [Ext Key] button can be
selected.

Setting Interpolation Processing

You can set the number of pixels and the anti-aliasing
mode used for interpolation processing.
1
Open the Home > DME > Channel1 > Input/Output >
Process menu (15101.03).
2
In the [Interpolation Mode] group, set the number of
pixels to use in interpolation.
Multi: Use multi-point interpolation.
Linear: Use two-point interpolation.
Note
The [Multi] button can be selected only when the
DME channel is set to enhanced function mode.
3
In the [Filter Mode] group, select an anti-aliasing
mode.
Mode1: Even when the picture is reduced, add
compensation so that it can be seen clearly
(standard).
Mode2: Suppress aliasing when enlarging or reducing
the picture (soft).
Adjustment
Key gain
Adjustment
Reference level for key signal
generation
Key gain
Mode3: Do not suppress aliasing when enlarging or
reducing the picture (sharp).
160