Setting A Tally Group; Setting Wiring - Sony XVS-G1 User Manual

Setting a Tally Group

You can select a tally group (1 to 8) controlled using NS-
Bus. You can set multiple tally groups.
1
Open the Home > Setup > Router/Tally > Tally >
Group Tally menu (19106.21).
2
In the [Tally Group] group, select a tally group (Group
1 to Group 8).
3
Enable/disable the tally using the [NS-Bus Tally
Enable] button.
On: Enable tally control using NS-Bus.
Off: Disable tally control using NS-Bus.

Setting Wiring

You can set output and input connection information
(wiring) in NS-Bus space.
The wiring settings are common to both parallel tally and
serial tally.
1
Open the Home > Setup > Router/Tally > Tally >
Wiring menu (19106.22).
2
Select the target wiring to set.
To select and set multiple wiring, place a check mark
beside the target wiring to set.
You can also press the [Select Number(s)] button and
enter a wiring number in the numeric keypad window.
Note
The maximum number of wiring settings that can be
set at the same time is 128.
3
Press the [Source] button and enter an address for a
source in the numeric keypad window.
Note
If multiple consecutive wiring settings are selected,
consecutive addresses from the entered address are set.
4
Press the [Src Level] button and enter a source level (1
to 8) in the numeric keypad window.
5
Press the [Destination] button and enter an address for
a destination in the numeric keypad window.
Note
If multiple consecutive wiring settings are selected,
consecutive addresses from the entered address are set.
6
Press the [Dest Level] button and enter a destination
level (1 to 8) in the numeric keypad window.
To delete wiring settings
Select the target wiring to delete and press the [Delete]
button.
341