Setting Button And Indicator Status On The Cross-Point Control Block/Aux Bus Control Block; Configuring The Cross-Point Pad - Sony XVS Series User Manual

Setting Button and Indicator Status
on the Cross-Point Control Block/
AUX Bus Control Block
Setting the color of cross-point buttons
This sets the color of the 3rd row/4th row cross-point
buttons.
1
In the Engineering Setup >Panel >Operation menu
(7326), press [Xpt Module Operation].
The Xpt Module Operation menu (7326.12) appears.
2
In the <Bank Select> group, select the target bank to
set.
3
In the <Xpt Button Color> group, select one of the
following.
Source Color: Lit using the color set in the
Engineering Setup >Panel >Xpt Assign >Src
Name/Src Color menu (7322.6).
White: Lit white.
Setting cross-point indicators
You can disable the cross-point indicators so that they do
not turn on.
1
In the Engineering Setup >Panel >Operation menu
(7326), press [Xpt Module Operation].
The Xpt Module Operation menu (7326.12) appears.
2
In the <Bank Select> group, select the target bank to
set.
3
Press [Xpt Indicator], turning it off.
To enable the cross-point indicators so that they do
turn on, press [Xpt Indicator] again, turning it on.

Configuring the Cross-Point Pad

Assigning a function to a cross-point pad
button
1
In the <Xpt Pad> group of the Engineering Setup
>Panel >Operation >Xpt Module Operation menu
(7326.12), press [Xpt Pad Btn Assign].
The Xpt Pad Btn Assign menu (7326.14) appears.
The left side of the status area shows the currently
display page number and buttons, and the right side of
the status area shows a list of assignable functions.
2
In the <Bank Select> group, select the target bank to
set.
3
Select the target page to set.
No. Parameter Adjustment
1 Page
4
Press the target button to make an assignment.
5
In the list on the right, select the function to assign.
6
Press [Set].
To assign a page recall function
You can set to display a specific page when a button on the
cross-point pad is pressed.
1
Select the target button display to set, and press [Jump
Page].
2
Enter the page number to display (1 to 14) using the
numeric keypad window, then press [Enter].
To disable the page recall function, enter "0."
To release the assignment
Select the target button to release, then press [Clear].
To return the assignment to the default
Press [Default Recall], check the message, then press
[Yes].
To rename a page
1
Select the target page number to set, and press [Page
Name].
2
Enter a name of up to 12 characters in the keyboard
window, and press [Enter].
Note
Lower case characters may be entered, but the entered
characters are displayed as upper case characters on
the buttons in the cross-point pad.
About re-entry button assignment
The following re-entry buttons can be assigned to buttons
on the cross-point pad.
• ROW-n P/P OUT1, ROW-n M/E-1 OUT1 to ROW-n M/
E-5 OUT1 (n = 1 to 4)
• ROW-n P/P OUT6, ROW-n M/E-1 OUT6 to ROW-n M/
E-5 OUT6 (n = 1 to 4)
396
Page selection