Service manual Kona cutting plotter
Part replacement
3.4.7
Y-origin flex PCB
Tools necessary
P2 screwdriver
Hexagon wrench 5,5 mm
Hexagon key 2,5 mm
Replacement procedure
Follow the procedure below to replace the Y-origin flex PCB.
Step 1:
Step 2:
Step 3:
Step 4:
Adjustments necessary
After replacing this part, it is necessary to make the following adjustment.
N°
1
52
Remove the following covers first
Side covers
Y-rail cover
Penhead cover
Refer to
Cover removal on page 27
Remove the penhead assembly.
Refer to
Penhead assembly > Penhead assembly on page 44
Loosen the 2 screws fixing the Y-origin flex PCB.
Replace the Y-origin flex PCB.
Description
EPOS calibration
EPOS calibration on page 103
Link
AP-74380 - Revision 1.1