Fujitsu MB90335 Series Hardware Manual page 347

CHAPTER 14 16-BIT RELOAD TIMER
14.2 Registers of 16-bit Reload Timer
[bit1] CNTE (timer counter permission)
It is a bit by which the timer counter is permitted.
CNTE
0
1
[bit0] TRG (Software trigger)
It is Software trigger bit. When "1" is written on the TRG, the software trigger is applied so that the
reload register contents of timer is loaded to the counter to start the count operation. Writing "0" has no
meaning. Reading is always "0". Always enabled only when the CNTE value is "1" regardless of the
operation mode.
TRG
0
1
326
Counter permission (startup trigger waiting)
There is no change (There is no influence on another).
Count operation start
FUJITSU MICROELECTRONICS LIMITED
Function
Counter stop [Initial value]
Function
MB90335 Series
CM44-10137-6E