NEC Electra Elite IPK II Features And Specifications Manual page 961
Hide thumbs
Also See for Electra Elite IPK II:
- User manual (1190 pages) ,
- System hardware manual (642 pages) ,
- Programming manual (617 pages)
Table of Contents
Advertisement
Electra Elite IPK II
4.
Access Network Settings and press 2 to enter the IP address for the telephone. The IP address
must be unique to each telephone but the range is dependent upon system programming
(example: IP Multiline Terminal 1 = 172.16.0.11, IP Multiline Terminal 2 = 172.16.0.12, etc.). The
∗
key is used to move to the next set of three digits (example: 172
"OK".
For on-site LANs, the IP address must be unique to each telephone but the range is dependent upon system
programming (example: IP Phone 1 = 172.16.0.11, IP Phone 2 = 172.16.0.12, etc.). When telephones are
off-site (remote LAN) , these settings are dependant on the remote LAN settings - not the telephone system
settings.
The Softkey "BK" backs up a character to correct an entry.
5.
Access Network Settings and press 4 to enter the Default Gateway address.
For on-site LANs this is the entry in Program 10-12-03. When telephones are off-site (remote LAN) , these
settings are dependant on the remote LAN settings - not the telephone system settings.
6.
Access Network Settings and press 4 to enter the Subnet Mask.
For on-site LANs this is the entry in Program 10-12-02. When telephones are off-site (remote LAN) , these
settings are dependant on the remote LAN settings - not the telephone system settings.
7.
Press 3 to enter the IP telephone's extension number.
8.
Press 2 to enter the MGC IP Address (Media Gateway Controller ). Enter the IP address used in
Program 84-05-01 (default: Slot 1 -172.16.0.20). The
digits (example: 172
The Softkey "BK" backs up a character to correct an entry.
9.
Press the softkey SAVE to save the entries and return the telephone to an idle condition.
Pressing CANCEL instead will ignore the changes made and return the multiline terminal to an idle condition.
Voice Over Internet Protocol (VoIP)
Figure 2-14 Selecting DHCP Mode
∗
∗
∗
16
0
10). Press the Softkey OK.
∗
∗
∗
16
0
10). Press the Softkey
∗
key is used to move to the next set of three
Document Revision 1
2 - 939
Advertisement
Table of Contents
