NEC Electra Elite IPK II Features And Specifications Manual page 762

Document Revision 1
Related Features
Distinctive Ringing, Tones and Flash Patterns
Programming
11-11-20 Service Code Setup (for Setup/Entry Operation) - Change Incoming CO and ICM Ring
Tones
If required, change the service code used for changing the incoming ring tones heard for CO and
ICM calls (Default: 720).
11-11-21 Service Code Setup (for Setup/Entry Operation) - Check Incoming Ring Tones
If required, change the service code used for checking how the incoming ring tones sound.
(Default: 711).
15-02-02 Multi-Line Telephone Basic Data Setup - Trunk Ring Tone
Use this option to set the tone (pitch) of the incoming trunk ring for the extension port you are
programming.
1 = High
2 = Mid Range
3 = Low
4 = Ring Tone 1
15-02-03 Multiline Telephone Basic Data Setup - Internal Ring Tone
Use this option to set the tone (pitch) of the incoming extension call ring for the extension port
you are programming. Also refer to program 15-08.
1 = High
2 = Mid Range
3 = Low
4 = Ring Tone 1
15-08-01 Incoming Virtual Extension Ring Tone Setup
Assign a ring tone pattern (0~4) to incoming virtual extensions assigned to a Virtual Extension
key (Program 15-07). If you enable ringing for the key in Program 15-09, the key rings with the
tone you set in this program. Also see Program 22-03.
2 - 740
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
Electra Elite IPK II
Selectable Ring Tones