NEC Electra Elite IPK II Features And Specifications Manual page 330

Document Revision 1
14-01-13 Basic Trunk Setup - Loop Disconnect Supervision
If DISA caller can place outgoing calls through the system (refer to Program 20-14 in the Electra
Elite IPK II Programming Manual), enable loop supervision (1) for the DISA trunk. If DISA caller
cannot use the system's trunks for outgoing calls, enter 0 to disable loop supervision.
20-01-05 System Options - DTMF Receiver Active Time
After answering the call, the system attaches a DTMF receiver to the DISA trunk for this interval
(0~64800 seconds).
20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
20-09-01 Class of Service Options (Incoming Call Service) - Second Call for DID/ DISA/ DIL/ E&M
Enable (1) or disable (0) an extension's ability to receive a second call from a DID, DISA, DIL, or
tie line caller.
20-13-23 Class of Service Options (Supplementary Service) - Display the Reason for Transfer
Enable (1) or disable (0) an extension's ability to display the reason (Call Forward, Busy, No
Answer or DND) a VRS, DID, DISA, or ISDN call is being transferred to their extension.
20-14-01 ~ 20-14-11
Enable (1) or disable (0) the following options for each DISA Class of Service (1~15).
First Digit Absorption (Item 1)
H
Trunk Group Routing/ARS Access (Item 2)
H
Trunk Group Access (Item 3)
H
System Speed Dialing (Item 4)
H
Operator Calling (Item 5)
H
Internal Paging (Item 6)
H
External Paging (Item 7)
H
Direct Trunk Access (Item 8)
H
Forced Trunk Disconnect (Item 9)
H
Call Forward Setting by Remote Via DISA (Item 10)
H
DISA/Tie Trunk Barge-In (Item 11)
H
21-15-01 Alternate Trunk Route for Extensions
Designate the trunk route accessed when a user dials the Alternate Trunk Route Access Code.
Refer to "Trunk Group Routing" to set up outbound routing.
22-01-11 System Options for Incoming Calls - VRS Waiting Message Interval Time
Setup the duration time between announcing the VRS Waiting Message for Auto - Attendant &
Queuing. The message is repeatedly sent out within the specified time (0~64800 seconds).
22-02-01 Incoming Call Trunk Setup
For DISA operation, set the trunk service type to 2. You can have a different service type for
each Night Service mode.
2 - 308
Class of Service Options for DISA/E&M
Electra Elite IPK II
Direct Inward System Access (DISA)