NEC Electra Elite IPK II Features And Specifications Manual page 625

Electra Elite IPK II
34-01-02 E&M Tie Line Basic Setup - DID/E&M Start Signaling
Set the trunk signaling type to either dial pulse (0) or DTMF (1).
34-01-03 E&M Tie Line Basic Setup - E&M Dial-In Mode
Determine if the incoming tie line call should be directed as an intercom call or if it should follow
the DID Translation Table in Program 22-11-01.
34-01-04 E&M Tie Line Basic Setup - E&M Line Dial Tone
Enter (1) if the tie line should send dial tone to the calling system once the call is set up. Enter
(0) if the tie line should not send dial tone.
34-01-05 E&M Tie Line Basic Setup - System Toll Restriction
Enable (1) or disable (0) the ability for tie line calls to follow the system toll restriction entries in
Programs 21-05-01 through 21-05-13. If disabled, tie line toll restriction will be determined by 21-
05-13.
34-02-01 E&M Tie Line Class of Service
Assign the tie line's Class of Service (1-15). Use Program 20-14-01 to set the tie line Class of
Service options. You cannot use Programs 20-06 thru 20-17 to assign Class of Service to tie
lines.
34-03-01 Trunk Group Routing for E&M Tie Lines
Use this program to assign the trunk group route chosen when a user seizes a tie line and dials
9. Set Trunk Group Routing in program 14-06-01. If the system has ARS, dialing 9 accesses
ARS.
34-04-01 E&M Tie Line Toll Restriction Class
If the system uses Toll Restriction, enter a Toll Restriction Class (1-15) for each tie line. The
system uses the class you enter in Program 21-05-01. You cannot use Program 21-04 to assign
Toll Restriction to tie lines.
34-05-01 Tie Line Outgoing Call Restriction
This program lets you build a restriction matrix for trunk calls placed over a tie line. For each tie
line trunk group, enable (0) or disable (1) outgoing access to each CO trunk group.
34-06-01 Add/Delete Digit for E&M Tie Line - Delete Digit
Some tie line networks pass the location number and extension number to the remote side. If the
system should ignore these digits, use this program to define the number of digits which should
be deleted (0-255, 255 deletes all digits) for a call.
34-06-02 Add/Delete Digit for E&M Tie Line - Additional Dial Digits
If a tie line network requires additional digits to reroute the call to a location, enter the digits for
the location which should be added to the received digits (up to 4 digits).
34-07-01~05E&M Tie Line Timers
Define the system timers as needed for use with the tie line trunks.
Multiple Trunk Types
Document Revision 1
2 - 603