NEC Electra Elite IPK II Features And Specifications Manual page 828

Hide thumbs Also See for Electra Elite IPK II:
Table of Contents

Advertisement

Document Revision 1
Programming
10-03-01
ETU Setup
Set various T1 trunk options for compatibility with the local Telco. For ANI/DNIS, the following
settings in Program 10-03 are recommended:
Item 02: Frame Type = 0 (D3/D4)
H
Item 03: Zero Suppression = 1 (AMI/ZCS)
H
Item 04: Distance Between ETU and CSU = 0 (0~133')
H
Item 05: Clock Select = 1 (Internal)
H
10-09-01
DTMF and Dial Tone Circuit Setup
For ANI/DNIS, reserve at least one DTMF receiver for DTMF reception (entry 0 or 2).
Use the following as a guide when allocating DTMF receivers:
H
L
L
14-01-02
Basic Trunk Data Setup - Transmit CODEC Gain Type
14-01-03 : Basic Trunk Data Setup - Receive CODEC Gain Type
Assign a CODEC Gain Type to each trunk. This sets the amount of gain (amplification) for the
selected trunk.
14-01-07
Basic Trunk Data Setup, Outgoing Calls
For ANI/DNIS, the following additional setting is recommended: Outgoing Calls = 1 (Allowed)
14-02-01
Analog Trunk Data Setup - Additional ANI/DNIS Recommended Settings
For ANI/DNIS, the following additional settings in Program 14-02 are recommended:
Item 1: Signaling Type (DP/DTMF) = 2 (DTMF)
H
Item 2: Ring Detect Type = 1 (Immediate)
H
Item 3: Flash Type = 0 (Open Loop Flash)
H
Item 4: Flash for Time Flash or Disconnect = 0 (Timed Flash)
H
Item 5: Dial Tone Detection for Manually Dialed Calls = 1 (Outgoing calls allowed)
H
14-02-02
Analog Trunk Data Setup - Ring Detect Type
Set the trunks for Extended Ring Detect or Immediate Ring Detect. For T1 loop/ground start
trunks, this option must be set to '1' in order for the trunks to ring and lamp correctly.
14-04-01
Behind PBX Setup: Behind PBX
For ANI/DNIS, the following additional setting is recommended: Behind PBX = 0 (Stand Alone).
14-05-01
Trunk Groups
For ANI/DNIS, place all your ANI/DNIS trunks in Trunk Groups as required.
2 - 806
In light traffic sites, allocate one DTMF receiver for every 10 devices that use them.
In heavy traffic sites, allocate one DTMF receiver for every 5 devices that use them.
T1 Trunking (with ANI/DNIS Compatibility)
Electra Elite IPK II

Advertisement

Table of Contents
loading

Table of Contents