NEC Electra Elite IPK II Features And Specifications Manual page 545

Electra Elite IPK II
10-03-08 ETU Setup - Dial Sending Mode
Setup and confirm the Basic Configuration data for each BRT (4)-U20 ETU. Select either
enblock or overlap sending.
0 = Enblock Sending
1 = Overlap Sending (Default)
10-03-09 ETU Setup - Dial Information Element
Setup and confirm the Basic Configuration data for each BRT (4)-U20 ETU. If Overlap Sending
is selected in Program 10-03-08, select either Keypad Facility (0) or Called Party Number (1) for
the dial information element.
10-03-17 ETU Setup
10-03-18 ETU Setup
10-03-19 ETU Setup
10-06-01 ISDN BRI Setup - TEI Selection
Select the method the system will use when assigning Terminal Endpoint Identifier (TEI) values
to the BRI Circuit.
0 = Select by SPID number (Default)
1 = Select by Channel ID number
10-06-02 ISDN BRI Setup – DID Mode
Select the method the system will use when assigning DID Mode to the BRI Circuit.
0 = Route by Called Party Number (default).
1 = Route by Redirecting Number
10-06-03 ISDN BRI Setup - SPID 1
Assign the SPID Number for B-Channel 1 (maximum of 20 Digits allowed).
10-06-04 ISDN BRI Setup - SPID 2
Assign the SPID Number for B-Channel 2 (maximum of 20 Digits allowed).
21-12-01 ISDN Calling Party Number Setup for Trunks - Calling Party Number Data
Assign Calling Party Numbers for each trunk (maximum 16 digits per entry).
After the above programming is complete a reset of the BRT (4)-U20 ETU is required.

ISDN - PRI Installation
10-03-01 ETU Setup - ISDN Line Mode
Setup and confirm the Basic Configuration data for each DTI ( )-U40 ETU. Use this program to
select the ISDN Line Mode:
0 = Not Set
1 = T-Bus (Default)
ISDN Compatibility
Document Revision 1
2 - 523