NEC Electra Elite IPK II Features And Specifications Manual page 55

Electra Elite IPK II
Physical Ports and Software Ports
Each PGD(2)-U10 ADP consists of a physical port for connection to the telephone system and two logical
ports. For programming purposes, the ports are also called software ports. The physical port connects to a
station position on a ESI ETU. During installation, the first PGD(2)-U10 ADP you set up is physical port 1;
the second PGD(2)-U10 ADP is physical port 2, etc. Each PGD(2)-U10 ADP has two software ports,
which are numbered independently of the physical ports. Normally, the first PGD(2)-U10 ADP set up has
software ports 1-2; the second PGD(2)-U10 ADP has software ports 3-4, etc. There are a total of 96
software ports (48 PGD(2)-U10 ADPs x 2 ports each). During programming, you assign ACI extension
numbers and Department Group options to PGD(2)-U10 ADP software ports, not physical ports. During
installation, you connect equipment to the jacks on the PGD(2)-U10 ADP that correspond to the software
port. Refer to the Electra Elite IPK II System Hardware Manual for installation details.
Conditions
r ACD agents who are logged on can be recorded.
r ACI software ports cannot be Background Music music sources.
An extension cannot have Hotline keys for ACI software ports. Music on Hold ACI software
r
ports can be Music on Hold music sources.
r An extension can have One-Touch Keys for ACI software ports. The gives the extension
user:
One-Touch access to external music
J
One-Touch External Paging
J
One-Touch loud ringer control
J
r ACI software ports can provide External Paging with control, independent of the External
Paging circuits on the CPUII ETU. The PGD(2)-U10 ADP can only be connected to an
ESIB(8)-U20 ETU. If the PGD(2)-U10 ADP is connected to an ESIE(8)-U20 ETU, the
PGD(2)-U10 ADP will NOT be recognized.
r When an ESIB(8)-U20 ETU has an ESIE(8)-U20 ETU installed [ESIB/E(16)], the
PGD(2)-U10 ADP will have both channels available for Paging, MOH, External Ringers,
and Door Box according to strapping on ports 1-8. The corresponding port on the
ESIE(8)-U20 ETU will not support a station or other hardware (it is used by the PGD(2)-U10
ADP for channel 2).
r When an ESIB(8)-U20 ETU is installed without an ESIE(8)-U20 ETU installed, a
PGD(2)-U10 ADP installed on ports 1~8 will be recognized, but only Channel 1 on the
PGD(2)-U10 ADP is supported. Channel 2 is not available.
r ESIB(8)-U10 ETUs and ESIE(8)-U10 ETUs do not support the PGD(2)-U10 ADP.
Analog Communications Interface (ACI)
Document Revision 1
2 - 33