NEC Electra Elite IPK II Features And Specifications Manual page 826
Hide thumbs
Also See for Electra Elite IPK II:
- User manual (1190 pages) ,
- System hardware manual (642 pages) ,
- Programming manual (617 pages)
Table of Contents
Advertisement
Document Revision 1
A VRS and play a VRS message to the caller
N
A Department Group pilot number
N
A trunk Ring Group
N
Route According to DID Translation Table or Abbreviated Dial Bins
J
Calls can be routed based on either the number of digits defined in Program 22-09-01 (digits 1~8)
or by digits entered in Abbreviated Dial bins in Program 13-04-01.
ANI/DNIS Data Displayed as Caller ID Data
Data Error and Unanswered Call Handling
J
If a call can not be completed, send it to a predetermined Ring Group or play supervisory tones to
the caller.
Conditions
T1 Trunking requires a T1/PRI Interface ETU and a customer-provided CSU/DSU to
r
interface with the Telco. Consult your sales representative and the system Hardware
Manual for additional details.
r
ANI/DNIS Compatibility requires the use of system DTMF receivers. When all receivers are
busy, the incoming ANI/DNIS call waits for a receiver to become available.
The ANI/DNIS/Address data received from the Telco can be up to 10 digits long.
r
r
An extension's Class of Service (Program 20-09-02) determines whether ANI information is
displayed.
Refer to
r
tone.
r
The T1 tie line can be used for networking.
The T1/PRI Interface ETU provides tie line service. All programming parameters are the
r
same as those used for analog Tie lines (except for the additional T1/PRI Interface ETU
settings).
r
DTI-U(40) ETUs can be installed in any Interface slot (1~8) of any cabinet (1~3).
r
The DTI-U(40) ETU supports Dial Pulse and DTMF signaling.
r
With an Electra Elite IPK II - Expanded Port Package, up to 192 T1 trunks can be assigned.
You can use T1 trunks in place of standard analog trunks. The procedures for placing and
r
answering calls are the same for both types of trunks.
r
The T1/PRI Interface ETU provides DID service. All programming parameters are the same
as those used for analog DID trunks (except for the additional T1/PRI Interface ETU
settings).
2 - 804
Dial Tone Detection on page 2-267
for the specifics on how the system detects dial
T1 Trunking (with ANI/DNIS Compatibility)
Electra Elite IPK II
Advertisement
Table of Contents
