NEC Electra Elite IPK II Features And Specifications Manual page 685

Electra Elite IPK II
System Availability
Terminals
Not Applicable
Required Component(s)
Each copy of installed PC Programming requires a license.
Related Features
None
Programming
10-12-01 IPK II Network Setup - IP Address
Assign the CPU's IP address if PC Programming is required via LAN. This program item must be
set if WebPro access is required.
10-12-02 IPK II Network Setup - Subnet Mask
Assign the CPU's Sub Net Mask address if PC Programming is required via LAN. This program
item must be set if WebPro access is required.
10-12-03 IPK II Network Setup - Default Gateway
Assign the CPU's Gateway address if PC Programming is required via LAN. This program item
must be set if WebPro access is required.
10-21-02 IPK II Hardware Setup - Baud rate for COM Port
Assign the Baud rate for COM Port 1 (Side of KSU) COM 1, (Default 2, 19200). If a direct or
remote (modem) connection is required via PC Programming then this PRG must be set.
11-15-14 Service Code Setup, Administrative (For Special Access) - Modem Access
Assign the service code to be used to access the internal modem on the CPU.
22-02-01 Incoming Call Trunk Setup
Define the service type for the trunk intended to access the internal modem as 4:DIL.
22-07-01 DIL Assignment
Assign the Modem Access service code set in 11-15-14 as the destination extension for the DIL
trunk for modem access.
PC Programming
Document Revision 1
2 - 663