NEC Electra Elite IPK II Features And Specifications Manual page 391

Electra Elite IPK II
r The Gateway power supply and cables should be installed away from high power/high RF
noise devices such as computers, fans, fluorescent ballast, or power supplies.
Good wiring practices are required. Do not run wires across devices such as fluorescent
r
lights, computers, or air conditioners to avoid introducing noise in the modems.
r The distance between the PBX/KTS and the Gateway unit must not exceed 500 feet.
When 5-, 6-, or 7-digit station numbers are used, this feature is not available.
r
Default Setting
None
System Availability
Terminals
DTU/DTP/DTR Multiline Terminals
r
r DTP-32DE-1 for home environment
Required Component(s)
Components include the following:
r Electra Elite IPK II KTS with 1 ESI port for each Branch port and IP Adapter
r Gateway unit
Branch unit and/or IP Adapters with total ports not exceeding the number of ports
r
supported by the Gateway unit
r Power Cord
RS-530 cable
r
2 RJ-21 50 pin cables to connect Gateway to DTS and Branch to punch block – connectors
r
required include a female connector to attach to D
the KTS.
r Punch blocks that can cross connect the D
telephones to the branch locations
Installation hardware for Gateway and Branch units
r
r System Administrator's Guide
r Quick Installation Guide
term
D IP Gateway System
term
IP, and a male connector to attach to
term
IP Gateway to the KTS and D
Document Revision 1
term
2 - 369