NEC Electra Elite IPK II Features And Specifications Manual page 830

Document Revision 1
34-09-01 ANI/DNIS Service Options - Receive Format
Use this option to specify the format of the ANI/DNIS data received from the Telco. Make sure
your entry is compatible with the service the Telco provides (0 = Address, 1 =
2 = *DNIS*, 3 =
34-09-02 ANI/DNIS Service Options - Delimiter Dial
This option defines the character Telco uses as a delimiter (see entries 1~5 in 34-09-01).
Valid entries are: 0~9, #, and
34-09-03 ANI/DNIS Service Options - Route Setup of Receive Dial
This option specifies the source of the data the system uses to route incoming ANI/DNIS calls. If
option '2' is selected, refer to Program 34-09-04:
0 = Fixed Route (Item 08)
1 = Routes on Received DNIS or Address Data
2 = Routes on Received ANI Data
34-09-04 ANI/DNIS Service Options - Route Table Setup of Target Dial
The option sets how the system uses the route data (gathered in Item 3) to route incoming ANI/
DNIS calls (0 = ABB Table [Program 13-04], 1 = DID Table [Program 22-11]).
If option '2' is selected and the call is to be routed using the DID table (1), up to 8 digits can be
matched. The number of expected digits set in Program 22-09-01 must match the ANI digits
defined in Program 22-11-01. For example, if an ANI/DNIS number received was
∗
2035551234
the defined target extension.
If the call is to be routed using the ABB table (0), up to 24 digits can be matched. Define the
range of the ABB table to be used in Program 34-09-06. The data is then compared to the
entries in Program 13-04-01 and then routed according to Program 13-04-03.
34-09-05 ANI/DNIS Service Options - ANI/DNIS Display as Target Dial Name
Use this option to set if ANI data should appear on telephone displays as part of Caller ID
display.
Caller ID Display:
0 = Display Off
1 = Display On
34-09-06 ANI/DNIS Service Options - Routing SPD Dial Table Setup
Use this option to define which part of the SPD Dial Table set up in Program 13-04 the system
will use for ANI/DNIS Caller ID look-ups and ANI/DNIS routing (Start = 0, 100~1900, End = 0,
99~1999). This is required if Items 4 and 5 above are 1 (Caller ID on). When you specify a
starting and end address, the system uses the part of the table for look-ups. When you specify a
starting address and length, the system uses that part of the table for routing. If the incoming
ANI/DNIS number data matches the Number entry in the table, the system routes according to
the associated Name data. That data can be an extension, Department Group pilot number, the
voice mail master number or a trunk ring group.
2 - 808
∗ ∗ ∗
ANI Address , 4 =
.
,
∗ ∗
3001 and Program 22-09-01=4, then the entry in 22-11-01 must be 1234 with
∗ ∗ ∗
ANI DNIS , 5 = *DNIS
T1 Trunking (with ANI/DNIS Compatibility)
Electra Elite IPK II
∗ ∗
ANI ,
∗ ∗ ∗
ANI [ = Delimiter Code]).