NEC Electra Elite IPK II Features And Specifications Manual page 867

Electra Elite IPK II
15-02-24 Multiline Telephone Basic Data Setup, Conference Key Mode
This option allows an extension's Conf key to be programmed for Conference or for Transfer.
When set for Transfer (1), the user places a call on hold, dials the extension to which it should
be transferred, the presses the Conf key. The call is then transferred. When set for Conference
(0), with an active call, the user presses the Conf key, places a second call, then presses the
Conf key twice. All the calls are then connected.
20-02-04 System Options for Multiline Telephones - Retrieve the Line After Transfer
Enable (1) or disable (0) an extension's ability to answer a call after it's been transferred, but
before it's answered.
20-03-01 System Options for Single Line Telephones - SLT Call Waiting Answer Mode
For a busy single line (500/2500 type) telephones, set the mode used to answer a camped-on
trunk call.
Modes:
0 = Press and release hookswitch to pick up waiting call
1 = Press and release hookswitch and dial Service Code 794 (Call Waiting Answer/Split Answer
for SLT) to answer waiting call.
24-02-02 System Options for Transfer - MOH or Ringback on Transferred Calls
Use these options to enable (0) or disable (1) MOH on Transfer. If enabled (0), a transferred
caller hears Music on Hold while their call rings the destination extension. If disabled (1), a
transferred caller hears ringback while their call rings the destination extension. For this option to
work with voice mail, the transferred call must be an unscreened transfer.
20-06-01 Class of Service for Extensions
Assign a Class Of Service (1~15) to extensions.
20-11-06 Class of Service Options (Hold/Transfer Service) - Unscreened Transfer
In an extension's Class of Service, enable (1) or disable (0) the extension's ability to use
Unscreened Transfer.
20-11-07 Class of Service Options (Hold/Transfer Service) - Transfer Without Holding
In an extension's Class of Service, enable (1) or disable (0) the extension's ability to use
Transfer Without Holding.
20-11-08 Class of Service Options (Hold/Transfer Service) - Transfer Display
In an extension's Class of Service, enable (1) or disable (0) the extension's incoming Transfer
pre-answer display.
20-11-11 Class of Service Options (Hold/Transfer Service) - Automatic On Hook Transfer
In an extension's Class of Service, enable (1) or disable (0) the extension's ability to use
Automatic On Hook Transfer. If enabled, user must press Hold and dial the extension number to
Transfer the call. If disabled, a user must have a Transfer Programmable Function Key. To
transfer the call, the user would press Hold, dial the extension number, then press the Transfer
Programmable Function key to complete the transfer.
Transfer
Document Revision 1
2 - 845