NEC Electra Elite IPK II Features And Specifications Manual page 317

Electra Elite IPK II
25-06-02 VRS/DISA One-Digit Code Attendant Setup
Set up single digit dialing for Automated Attendant callers. For each VRS Message programmed
to answer outside calls, specify:
The digit the Automated Attendant caller dials (1~12, where 10 = 0, 11 =
H
mind that if you assign destinations to digits 3 and 4, outside callers will not be able to dial system
extensions.)
The destination reached (four digits maximum) when the caller dials the single digit code.
H
25-07-01 System Timers for VRS/DISA - VRS Dial Tone Time
After answering a VRS/DISA trunk, the system waits this interval for the caller to dial the first
digit of the DISA password. If the caller fails to dial within this interval, the system drops the call
(0~64800 seconds).
25-07-02 System Timers for VRS/DISA - VRS/DISA No Answer Time
A VRS/DISA caller can ring an extension for this interval before the system sets the call as a
Ring No Answer. After this interval expires, the call follows the programmed Ring No Answer
routing (set in Program 25-03 and 25-04) (0~64800 seconds).
25-07-04 System Timers for VRS/DISA - Calling Time to Automatic Answering Telephone Set
Set the answering waiting time of the automatic answering extension when an incoming DID
trunk call is received (0~64800 seconds).
25-07-05 System Timers for VRS/DISA - Duration Time for Guidance Message by Automatic
Answering Telephone Set
Set the announcement time of the automatic answering extension after which in incoming DID
trunk caller is disconnected (0~64800 seconds).
25-07-06 System Timers for VRS/DISA - Duration Time for Guidance Message by ACI
Set the announcement time by the ACI after which an incoming DID trunk caller is disconnected
(0~64800 seconds).
25-07-11 System Timers for VRS/DISA - VRS/DISA Answer Delay Timer
Set up the interval time the system will wait after receiving an incoming VRS/DISA call until the
system will automatically answer the call (0~64800 seconds).
25-07-13 System Timers for VRS/DISA - VRS/DISA Busy Tone Interval
If a DISA caller dials a busy extension (and Program 25-04-01 = 0), the system plays busy tone
for this interval before disconnecting (0~64800 seconds).
25-07-14 System Timers for VRS/DISA - Delayed DID Answer Timer
Assign the delay time from switching from a normal incoming status to DID mode. If this time is
set to '0', the call will switch to DID mode immediately (0~64800 seconds).
Direct Inward Dialing (DID)
Document Revision 1
and 12 = #). (Keep in
,
2 - 295