NEC Electra Elite IPK II Features And Specifications Manual page 368

Document Revision 1
Related Features
Flash
PBX Compatibility
Programming
11-12-42 Service Code Setup (for Service Access) - Flash on Trunk lines
#3 = Default
11-12-59 Service Code Setup (for Service Access) - Drop Operation, for SLT
Not assigned at default.
14-02-03 Analog Trunk Data Setup - Flash Types
Use this option to select the flash type.
0 = Open Loop Flash
1 = Ground
Always set this option for Open Loop Flash (0).
14-02-04 Analog Trunk Data Setup - Flash for Timed Flash or Disconnect
Use this option for each trunk, indicate if Flash is for one of the following:
0 = Timed Flash
1 = Disconnect
15-02-05 Multiline Telephone Basic Data Setup - Transfer Key Operation Mode
If the Conf key should access Flash, enter 2. Otherwise, enter 0 or 1.
15-03-04 Single Line Telephone Basic Data Setup - Flashing
In a single line (500/2500 type) telephone's Class of Service, enable (1) or disable (0) the ability
to hookflash for system feature access.
15-07-01 Programmable Function Keys
Assign a function key for Drop Key (code 84) if required.
20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
81-10-07 COI Initial Data Setup - Hookflash 1
Set the Flash duration (20 mS ~ 5.0 sec) for analog trunk [COI( )-U( ) ETU] circuits.
81-10-08 COI Initial Data Setup - Hookflash 2
Set the open loop disconnect duration (20 mS ~ 5.0 sec) for analog trunk [COI( )-U( ) ETU]
circuits.
2 - 346
Electra Elite IPK II
Drop Key