NEC Electra Elite IPK II Features And Specifications Manual page 879

Electra Elite IPK II
14-02-11 Analog Trunk Data Setup - Next Trunk in Rotary if No Dial Tone
Use this option to Disable (0) or Enabled (1) the system's ability to skip over a trunk if dial tone
is not detected. This pertains to calls using Call Appearance (CAP) Keys, Speed Dial, ARS, Last
Number Redial, or Save Number Dialed. It does not pertain to line keys or Direct Trunk Access
calls.
14-05-01 Trunk Groups
Assign trunks to trunk groups.
Trunk Groups: 1~200
14-06-01 Trunk Group Routing
Set up an outbound routing table for the trunk groups. When users dial 9, the system routes their
calls in the order (priority) you specify.
Trunk Groups: 1~200
Trunk Group Routes: 1~100
14-07-01 Trunk Access Map Setup
Assign trunks to Access Maps.
Trunk Access Maps: 1~200
15-06-01 Trunk Access Map for Extensions
Assign Access Maps to extensions.
Trunk Access Maps: 1~200
15-07-01 Programmable Function Keys
Assign function keys for trunk group access (code
(code
Trunk Groups: 1~100
20-02-02 System Options for Multiline Telephones - Trunk Loop Access Key Operating Mode
Set the operating mode of the extension's trunk group keys.
Operating Modes:
Incoming and Outgoing Access = 0
Outgoing Access =1
Incoming Access = 2
21-01-02 System Options for Outgoing Calls - Dial Tone Detection Timer
If dial tone detection is enabled, the system will wait this interval for the Telco to return dial tone.
When the interval expires, the system assumes dial tone is not present. To disable this timer
(and have the system wait continuously), enter 0.
Trunk Groups
∗
08 + CAP Key orbit 0001~9999 (or 0000 for auto assign).
Document Revision 1
∗
02 + group) or Call Appearance (CAP) Keys
2 - 857