NEC Electra Elite IPK II Features And Specifications Manual page 497

Electra Elite IPK II
15-05-07 Using IP Address
Use this program to review the registered IP Phones IP Address [Informational Only].
(default: 0.0.0.0)
15-05-15 Codec Type
Use this program to set the registered IP Phone Codec type – Reference 84-11 Dterm IP Codec
Basic Information.
(default: Type:1)
IP Phone Information Basic Setup:
84-03-06 IP Phone Information Basic Setup – Area
Use this program to set the country of origin.
(default: 1:USA)
84-03-07 Type of Service Mode
Use this program to define the marking the ToS Field.
(default: 1:Invalid)
84-03-08 Type of Service
Use this program to the define the Tos value.
(default: C0)
IP Extension Numbering:
11-02-01 Extension Numbering
Use this program to define the IP Phone extension Number.
This designated extension will be used to register your IP Phone and will be programmed IP Phone

programming. Refer to the Installation Instructions for Installation Instructions for Elite ITH-4D/8D/
16D-2/3 Dterm IPK Terminals and the IP-R (IPK) Adapters.
IP Phone Codec Information Basic Setup:
84-11-01 G711 Audio Frame
Use this program to define the G.71 audio Frame Size [ 1=10ms, 2=20ms, 3=30ms].
(default: 3 = 30ms)
84-11-02 G711 VAD Mode
Use this program to enable or disable Voice Activity Detection for G.711.
(default: 0:Disable)
84-11-03 G711 Type
Use this program to define the G.711 Type – Mu-law is recommended when in USA.
(default: 1: Mu-Law)
84-11-04 G711 Jitter Buffer Min
Use this program to define G.711 Jitter Buffer minimum accepted value –values are set in "ms".
(default: 30ms)
IP Station (MEGACO) - MG 16
Document Revision 1
2 - 475