NEC Electra Elite IPK II Features And Specifications Manual page 805

Hide thumbs Also See for Electra Elite IPK II:
Table of Contents

Advertisement

Electra Elite IPK II
The CTU Adapter
REQUIRES an AC/CD
power adapter.
In 35-01-02, define the extension number of
Refer to the
the multiline terminal with the CTU Adapter.
Electra Elite IPK
II System
Hardware
Manual for
Set the dip switches on the CTU Adapter to pins
further
installation
2, 5, 6 On (up); 1, 3, 4, 7, 8 Off (down).
details for the
CTU Adapter.
Install the CTU USB driver. Select 'non-procedure'
service during the installation of SMDR.
When connecting to the USB port using a communications
program (such as HyperTerminal), you can determine the
COM port used by checking the ports listing in the Device
Manager (right-click on "My Computer" and click on
The baud rate selected in the HyperTerminal does not
Attach ferrite beads to the AC-R power cable and USB
cables. (Install on the ends closest to the adapter.)
You may
want to
remove the
Without the line cord connected to the multiline terminal, install
wall mount
the CTU Adapter onto the multiline terminal and connect the AC/
bracket to
allow easier
installation
Connect the line cord to the multiline terminal.
Wait one minute for the system to recognize the adapter.
Check 10-03-04 for the multiline terminal.
Continue the USB cable to the adapter and PC.
Station Message Detail Recording
S M D R w i t h a C T U A d a p t e r
Start
In 35-01-01, set the SMDR output
to '4' for CTA/CTU
"Manage").
matter with the USB connection.
DC adapter.
Does it show the CTU installed?
Yes
Do NOT plug in the multiline
terminal with the CTU Adapter.
Was the
extension, on
which the CTU
Adapter is to
be installed,
previously
connected to
the system?
No
No
Set 15-02-19 to '0' for the
extension which will have the CTU
installed. (With PCPro/WebPro,
select 'Direct Print Mode'.)
Disconnect the telephone.
Undefine the multiline
No
terminal's port in 10-03-01.
Remove the CTU Adapter.
Go to
'A'.
Document Revision 1
Disconnect the
telephone and
undefine (set
Yes
to 0) the
multiline
terminal's port
in 10-03-01.
2 - 783

Advertisement

Table of Contents
loading

Table of Contents