New Holland CX720 Repair Manual page 4052

Return auger Bearing - Replace (K.62.C.53.22 - F.10.A.30)
1. Remove the access door from the side of the auger
discharge. Turn out cap screws (1) and lift the paddle
from the auger.
Set the new paddle in place and secure to the auger
shaft using two cap screws and lock washers.
Rotate the auger and check for interference. Adjust
the paddle as necessary.
2. Left Auger Paddle Replacement
Remove the access door from the side of the auger
discharge. Turn out cap screws (1) and lift the paddle
from the auger.
Set the new paddle in place and secure to the auger
shaft using two cap screws and lock washers.
Rotate the auger until the paddle is lined up with the
flow sensor. Set the gap (2) between the sensor
and paddle to 1 - 3 mm (0.039 - 0.118 in). Adjust
the position of the paddle as necessary to obtain the
required dimension.
CROP PROCESSING - CLEANING Tailings return system
2 4/7/2006
K.62.C / 60
1
40013931
2
40013932