7.
Pack the large bearing (1) and small bearing (2) with
NLGI 2 grease.
Install the large bearing (1) collar (3) snap rings (4),
gear (5) and small bearing (2) onto the output shaft
(6).
8.
Seat the large bearing (1) and collar (2) into the gear-
box case.
Install the snap ring (3) into the groove on the output
shaft to retain the collar and bearing.
NOTE: Be sure the bearing and collar are seated in the
bearing race as well as against the snap ring.
9.
Install the end cap shims (1) into the gearbox case
(2).
CROP PROCESSING - CLEANING Primary cleaning
K.62.B / 73
2 4/7/2006
7
40015024
8
40015025
9
40015026