4.
Remove the gear (1) from the gearbox case.
5.
Remove the bearing (1) and metal seal (2) from the
input shaft.
6.
Remove the bearing (1) and metal seal (2) from the
gearbox case.
7.
Inspection
8.
Clean all parts in a suitable solvent and allow to air
dry.
9.
Do not use compressed air to dry bearings as dam-
age could result.
10.
Rotate bearings by hand to check for roughness or
binding. Replace as necessary.
11.
Inspect the input shaft and gearbox, for wear, chips,
nicks, burrs and signs of heat discoloration. Repair
or replace as necessary.
CROP PROCESSING - CLEANING Tailings return system
2 4/7/2006
K.62.C / 32
4
20015091
5
20015092
6
20015093