New Holland CX720 Repair Manual page 4051

10. Set the lock collar (1) onto the end of the bearing.
Engage the collar with a hammer and punch opposite
the direction of rotation. Tighten the set screw (2).
11. Rotate the auger until a paddle is lined up with the
flow sensor. Verify the gap (1) between the sensor
and paddle is 1 - 3 mm (0.039 - 0.118 in). Adjust
the position of the paddle as necessary to obtain the
required dimension. Perform this step for both pad-
dles.
Install the access door.
CROP PROCESSING - CLEANING Tailings return system
2 4/7/2006
K.62.C / 59
10
40013927_1343
11
40013930