New Holland CX720 Repair Manual page 3789

7. Install a new stake nut (1) onto the input shaft (2).
Tighten the stake nut (1) to seat the bearing.
Loosen the stake nut and retighten to achieve the
proper rolling torque.
Use a torque wrench to tighten the nut (1) to obtain
1.5 - 3 N·m (13 - 26 lb. in.) of rolling torque.
When the rolling torque is set properly, use a punch
and a hammer to stake the nut (1) at the slot on the
input shaft.
8. Install the shims (1) onto the gearbox case (2).
9. Place the two gearbox halves together, making sure
to position the mounting holes (1) on the input case,
opposite of the grease fitting (2) on the output case.
Install the four mounting bolts (3).
Tighten the four mounting bolts (3) securely.
Check and adjust backlash. See Shoe drive sys-
tem Lower gearbox - Backlash (K.62.B.45.47 -
F.45.A.11).
CROP PROCESSING - CLEANING Primary cleaning
K.62.B / 77
2 4/7/2006
7
40015041
8
40015042
9
40015043