New Holland CX720 Repair Manual page 3786

10. Install the end cap (1) onto the gearbox case and
secure with the four mounting bolts (2).
Use a pull scale to check the rolling torque of the
assembled output shaft.
The rolling torque reading on the pull scale should be
0.18 - 0.4 N·m (1.6 - 3.5 lb. in.).
Adjust the rolling torque by adding or removing shims
under the end cap.
When the correct rolling torque is established, re-
move the end cap, place a 1/8 in bead of RTV gasket
sealer to the mating surface of the end cap.
11. Re-install the end cap and secure with the four
mounting bolts. Tighten the bolts securely.
CROP PROCESSING - CLEANING Primary cleaning
K.62.B / 74
2 4/7/2006
10
40015027