Drum Right hand bearing - Install (K.42.F.52.11 - F.10.A.15)
1.
Install bearing (1) in bearing housing (2).
Replace feltring (3), if necessary.
Install ring (4) on the straw flow beater shaft.
Install the bearing housing with the bearing on straw
flow beater shaft (5).
NOTE: Do not vibrate or hammer the bearing on the shaft.
Heat up the bearing until maximum 125 degrees C (257 F)
or press it on the shaft.
2.
Install and tighten four bolts (6).
Install ring (7).
3.
Install cover (8) and tighten the three bolts. Replace
feltring of the cover, if necessary.
Install grease line (9) and tighten nipple (10) to a
minimum torque of 8.5 Nm (6.3 ft.lbs).
CROP PROCESSING - SEPARATING Straw flow beater
2 4/7/2006
K.42.F / 12
1
ZDA4477A
2
ZDA4478A_1185
3
ZDA4435B_1186