New Holland CX720 Repair Manual page 3814

4. Set the pin and bushing assemblies in the upper shoe
frame. Turn in the four cap screws and lock washers
(1) Torque the cap screws to 150 - 170 N·m (111 -
125 ft. lbs.).
Disengage the leveling frame from the positioning
motor.
5. Rotate the leveling frame to make the right side ac-
cessible. Lift the shoe as necessary and install the
arm clamps (1) onto the bushings.
Rotate the leveling frame to make the left side acces-
sible. Repeat this procedure for the left side.
Do not tighten the hardware until instructed.
NOTE: A spacer is to be installed between the drive arm
and clamp at (2).
6. Lift the shoe as required and install the support arm.
Rotate the leveling frame to make the right side ac-
cessible. Repeat this procedure for the right side.
Do not tighten the hardware until instructed.
NOTE: The correct orientation of the support arm is: the
end with the smaller distance between the bushing and arm
surface is attached to the shoe at the top (1) The end with
the larger distance between the bushing and arm surface
is attached to the frame at (2).
CROP PROCESSING - CLEANING Primary cleaning
K.62.B / 102
2 4/7/2006
4
20013950_1202
5
50013948
6
20013949_1203