New Holland CX720 Repair Manual page 3830

4. Install the right side bearing (1) onto the fan shaft (2).
5. Measure the distance, X3, from the edge of the bear-
ing (1), to the end of the taper (2) on the fan shaft.
Position the bearing to achieve the measurement
shown in the table below that corresponds to the par-
ticular machine.
5 straw walker machines w/fixed cleaning shoe
5 straw walker machines w/self-leveling cleaning shoe
6 straw walker machines w/fixed cleaning shoe
6 straw walker machines w/self-leveling cleaning shoe
6. Install the bearing retainer (1) and re-check the mea-
surement. Tighten the retainer bolts and nuts (2) se-
curely.
Install the RH bearing lock collar (3) onto the bearing.
Use a punch and hammer in a clockwise direction, to
tighten the lock collar (3), onto the bearing. Tighten
the set screw (4) on the lock collar.
CROP PROCESSING - CLEANING Primary cleaning
Model
5
20013172
2 4/7/2006
K.62.B / 118
Measurement
228 mm (8.98 in)
254 mm (10.0 in)
228 mm (8.98 in)
254 mm (10.0 in)
4
20013170
6
20013168_1285