New Holland CX720 Repair Manual page 3624

Drum Shaft - Install (K.42.F.52.40 - F.10.A.15)
1. Insert shaft (1) with the keys on the upper side in the
straw flow beater sheaves from the left-hand side.
2. Install at the left-hand side bearing (5) in bearing
housing (6).
If necessary, replace feltring (12).
Install seal ring (7), ring (8) and circlip (9).
Install ring (10) on the straw flow beater shaft.
Install the bearing housing with the bearing on straw
flow beater shaft (11) with the four bolts.
NOTE: Do not vibrate or hammer the bearing on the shaft.
Heat up the bearing until maximum 125 degrees C (257 F
) or press it on the shaft.
3. Install the right-hand side straw flow beater bearing.
Refer to Drum - Install (K.42.F.52.01 - F.10.A.15).
4. Tighten four bolts (4) from the left-hand side bearing
housing.
Install ring (2) and key (1).
Install grease line (3) and tighten the nipple to a min-
imum torque of 8.5 Nm (6.3 ft.lbs).
5. Enter to the straw walkers and adjust the straw flow
beater in the middle of the frame.
CROP PROCESSING - SEPARATING Straw flow beater
2 4/7/2006
K.42.F / 6
1
ZDA4727A_1191
2
ZDA4476A_1192
3
ZDA4434A_1193