Figure 62: Adapting Sdos - WAGO 750-8215 Manual

266 CANopen Master and Slave
The value of the objects can be changed. To do this, mark the field in question in
the "Value" column and overwrite the value with your input, then press [Enter].
On initialization of the CAN bus, the set values will be transmitted to the slaves
as SDOs.
An example here is the activation of sending PDOs on a change in analog
values, which is normally deactivated:

Figure 62: Adapting SDOs

Manual
Version 1.2.0, valid from FW Version 03.02.02(14)
WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB