Mp Bus Master Module; Bluetooth ® Rf-Transceiver; Table 279: Mp Bus Master Module 750-643 - WAGO 750-8215 Manual

WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB

17.1.5.15 MP Bus Master Module

750-643
The MP Bus Master Module has a total of 8 bytes of user data in both the Input
and Output Process Image (6 bytes of module data and 2 bytes of control/status).
The following table illustrates the Input and Output Process Image, which have 4
words mapped into each image. Word alignment is applied.

Table 279: MP Bus Master Module 750-643

Input and Output Process Image
Offset
0
1
2
3
17.1.5.16 Bluetooth
750-644
The size of the process image for the Bluetooth
24 or 48 bytes.
It consists of one control byte (input) or status byte (output); an empty byte; an
overlay able mailbox with a size of 6, 12 or 18 bytes (mode 2); and the Bluetooth
process data with a size of 4 to 46 bytes.
Thus, each Bluetooth
image. The sizes of the input and output process images are always the same.
The first byte contains the control/status byte; the second contains an empty
byte.
Process data attach to this directly when the mailbox is hidden. When the
mailbox is visible, the first 6, 12 or 18 bytes of process data are overlaid by the
mailbox data, depending on their size. Bytes in the area behind the optionally
visible mailbox contain basic process data. The internal structure of the
®
Bluetooth
750-644 RF Transceiver.
The mailbox and the process image sizes are set with the startup tool WAGO-
I/O-CHECK.
Byte Destination
High Byte
C1/S1
D1
D3
D5
®
RF-Transceiver
®
module uses between 12 and 48 bytes in the process
process data can be found in the documentation for the Bluetooth
Version 1.2.0, valid from FW Version 03.02.02(14)
Low Byte
Extended
C0/S0 Control/
Status byte
D0
D2
D4
®
module can be adjusted to 12,
Appendix 363
Description
Control/status
byte
Data bytes
®
®
Manual