Configuration Of Snmp V1/V2C Parameters" Page; Snmp V1/V2C Manager Configuration" Group; Actually Configured Trap Receivers" Group(S); Table 95: Wbm "Configuration Of Snmp V1/V2C Parameters" Page - "Snmp - WAGO 750-8215 Manual

158 Commissioning

"Configuration of SNMP v1/v2c Parameters" Page

7.8.1.33
The general settings for SNMP v1/v2c are shown on the "Configuration of SNMP
v1/v2c Parameters" page.

7.8.1.33.1 "SNMP v1/v2c Manager Configuration" Group

Table 95: WBM "Configuration of SNMP v1/v2c Parameters" Page – "SNMP v1/v2c Manager
Configuration" Group
Parameter
Protocol enabled
Local Community Name
Click [Change] to apply changes. The changes only take effect after restarting
the controller. For this purpose, use the WBM reboot function. Do not shut down
the controller too early!

7.8.1.33.2 "Actually Configured Trap Receivers" Group(s)

Table 96: WBM "Configuration of SNMP v1/v2c Parameters" Page – "Actually Configured Trap
Receivers" Group
Parameter
Count
Manual
Version 1.2.0, valid from FW Version 03.02.02(14)
750-8215 PFC200; G2; 4ETH CAN USB
Explanation
It is displayed the SNMP protocol for v1/v2c is
activated. The local community name is deleted
when the protocol is deactivated.
Specify here the community name for the SNMP
manager configuration. The community name can
establish relationships between SNMP managers
and agents who are respectively referred to as
"Community" and who control identification and
access between SNMP participants.
The community name can be up to 32 characters
long and must not include spaces.
To use the SNMP protocol, a valid community name
must always be specified. The default community
name is "public."
Explanation
This displays number of configured trap receivers.
WAGO-I/O-SYSTEM 750