Canopen Slave Control Configuration; Figure 64: Attaching A Canopen Slave; Figure 65: Configuring A Canopen Slave - WAGO 750-8215 Manual

268 CANopen Master and Slave
10.3.5

CANopen Slave Control Configuration

An application must be configured in CODESYS before it can access the
connected CAN network.
To add the CANopen slave to the control configuration, right-click "COS
unused[Slot]" and select "Replace element -> CANopen slave".

Figure 64: Attaching a CANopen Slave

Right-click on CANopen Slave and select "Edit" to configure the slave.

Figure 65: Configuring a CANopen Slave

Manual
Version 1.2.0, valid from FW Version 03.02.02(14)
WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB