Table of Contents
Advertisement
WAGO-I/O-SYSTEM 750
750-8215 PFC200; G2; 4ETH CAN USB
7.8.1.34.3 "Add New v3 User" Group
You can enter 10 users.
Table 101: WBM "Configuration of SNMP v3 Users" Page – "Add New v3 User" Group
Parameters
Security Authentication
Name
Authentication Type
Authentication Key (min.
eight char.)
Privacy
Privacy Key (min. eight
char.)
Notification Receiver IP
Click [Add] to add a new user. The changes only take effect after restarting the
controller. For this purpose, use the WBM reboot function. Do not shut down the
controller too early!
Explanation
Enter the user name here. This name must be
unique; a pre-existing user name is not accepted
when entered here. The name can have a min. 8
and max. 32 characters and may contain lower case
letters (a ... z), upper case letters (A ... Z), numbers
(0 ... 9), special characters !()*~'.-_ but no spaces.
Specify the authentication type for the SNMP v3
packets.
Possible values:
- Use no authentication ("None")
- Message Digest 5 ("MD5")
- Secure Hash Algorithm ("SHA")
Specify the authentication key here. The key can
have a min. 8 and max. 32 characters and may
contain lower case letters (a ... z), upper case
letters (A ... Z), numbers (0 ... 9), special characters
!()*~'.-_ but no spaces.
Specify the encryption algorithm for the SNMP
message here.
Possible values:
- No encryption ("None")
- Data Encryption Standard ("DES")
- Advanced Encryption Standard ("AES")
Enter the key for encryption of the SNMP message
here. If nothing is specified here, the "authentication
key" is automatically used. The key can have a min.
8 and max. 32 characters and may contain lower
case letters (a ... z), upper case letters (A ... Z),
numbers (0 ... 9), special characters !()*~'.-_ but no
spaces.
Specify an IP address for a trap receiver for v3 traps
here. If no v3 traps are to be sent for this user, this
field remains blank.
Version 1.2.0, valid from FW Version 03.02.02(14)
Commissioning 161
Manual
Advertisement
Chapters
Table of Contents
Troubleshooting
